Chinese WeChat WeChat Hello, welcome to the official website of Dongguan Zhiyou Machinery Equipment Co., Ltd.
High precision reelCutting machineProfessional Manufacturer Papermate“wisdom”Create,rest assured、Peace of mind、Selected papermates!

National Service Hotline:0769-82669703

4News

The paper friend machine tells you what the high speed cutting machine is


High speed cutting machine is a kind of cutting machine. High speed slitting machine is a high efficiency and high precision processing equipment. Its greatest advantage is that the paper is processed without paper, and the paper is stacked and tidy. The specifications can be adjusted at any time and applied flexibly. Attention should be paid to the following details when using the slitter, which can be noticed from several aspects.

1, check the number of the joint of the section of the product is consistent with the number of its own. If the hot melt adhesive coating machine is not checked immediately to prevent the internal joint into the product.

2, according to the characteristics of semi-finished products, adjust the EPC device to ensure that EPC photoelectric is always on the tracking line, and one end of the membrane is pulled by hand to start the machine at low speed.

3. Stop pressing the stop button. When you unload the coil, your hand is not allowed to touch the reel to prevent your fingers from being clamped.

4, slow down, observe whether the cutting film meets the quality requirements, and then slowly speed up the start cutting, the machine runs, the hand is strictly forbidden to put into the machine, so as to avoid the hand back pressure.

5. To open the bracket of raw material to the appropriate width, put the semi finished film on the bracket, the hand must leave the film section when the material is on, and do not allow two people to operate at the same time, so as to prevent the hand from being trapped by the cylinder.

6. Return the photoelectric to the center position to ensure that the slider of the reel is kept in the middle of the guide stick.

7. Put the paper tube in accordance with the specifications on the receiving shaft, and turn the cut into the paper tube of the upper and lower collecting shaft according to the normal method, and open the machine at low speed, find the appropriate position of the paper tube on the receiving shaft, and make the mark for the next installation. When the paper tube is installed, the hand must grasp the surface of the paper tube to prevent slipping and bruising. All the cutting films are drawn onto the reel according to the operation requirements. When the hot melt adhesive machine is worn, the blade is not allowed to be scratched on the machine.

8. According to the order sheet, install the split cutter holder to the right position, fasten the lower knife, then start the machine at low speed, and cut the semi-finished product into the required specifications.

9, by opening the power of the machine, setting up the tension of the reel roll, the number of automatic stop of the counter and the thickness of the material according to the requirements on the task sheet, and opening the photoelectric.

Dongguan paper friend Machinery Equipment Co., Ltd. all rights reserved© Copyright 2018
National consultation hotline:0769-82669703 E-mail:2310434164@qq.com
company address:Xi'an West Road, Xi'an Village, Qishi Town, Dongguan City
Technical Support【Dongguan Website Construction】
*All website related materials and related resources are from the Internet. Please notify us if there is any infringement. We will delete it within 24 hours.*
Mobile phone sweep